Overview
Either way the controller generates the motion profile, handles I/O, and talks over serial, USB, or Ethernet, and you program it through a plain command protocol.
Controller Setup
First pass is telling it what it's driving: motor type, encoder, and the drive interface. It puts out step/direction for stepper drives and analog or PWM for servo drives:
- Set motor type: stepper (open loop) or servo (closed loop)
- Configure encoder resolution and direction
- Set acceleration/deceleration profiles (trapezoidal or S-curve)
- Define I/O assignments for home, limits, and general purpose
- Store configuration to non-volatile memory
Motion Profile Programming
The Commander builds the profile internally and feeds step pulses or analog commands to the drive. It'll do absolute positioning, relative moves, velocity mode, and electronic gearing. S-curve acceleration cuts vibration and jerk compared with a trapezoidal profile.
Stored Program Execution
For standalone jobs, you can store a motion sequence in the Commander's non-volatile memory and have it run on power-up or off a trigger input. That drops the host PC out of simple automation entirely. Stored programs handle conditional branching, loops, I/O monitoring, and timers.
Typical applications
- Single-axis positioning systems
- Automated test equipment
- Medical device motion control
- Standalone motion sequences
Related products
Commander 1 • Commander 2 • PCL Series. See them on the Nippon Pulse page or ask us for a quote.